Random good picture Not show

1 The piston and the cylinder bore may partially define a combustion chamber.

2 In diesel engine industry, the development of small cylinder bore and several cylinder bores diesel engine and spare parts is supported.

3 As the piston moves in the cylinder bore, the piston rings press against the cylinder wall, providing a seal for combustion gases and keeping lubricating oil from being burned.

4 The honed cross hatch in cylinder bore of engine and the cylindricity of cylinder bore shall affect directly the operating mode and life of engine.

5 The plume may extend into the cylinder bore a distance corresponding to the piston position.

6 The elect and shift cylinder bore and the size of other relevant parts were designed after the analysis of the structure of the vehicle's electing and shifting cylinder and the principle of shift.

7 Maintenance: Both cylinder bore and cylinder head valve guide tube can be repaired by resisting.

8 Hot load and mechanical load coupling make piston to produce crackle, piston-ring glued and scuffing of cylinder bore and so on.

9 The result shows that the device can reduce the contact force between the vane's outside and the cylinder bore wall and decrease the friction waste and abrasion of the vane compressor.

10 An integral contact model was established to analyze the cylinder bore deformation of model 493 automotive diesel engine.

11 Analyses the formation reasons, common characteristics and influence factors of diesel engine cylinder bore cavitation.

12 So the researches on this system will be of great significance. An electrical system is developed for measuring the variation of the friction force between piston ring and cylinder bore.

13 Reciprocating pumps convert rotary motion to linear motion. Pump speed in rpm determines the pumps output volume for any given combination of cylinder bore and piston stroke.

14 Coat rubber cups with oil, then partly insert into cylinder bore.

15 Pump speed in rpm determines the pumps output volume for any given combination of cylinder bore and piston stroke.

16 The parameter design of the plastic piston ring refers to designing the piston ring thickness, piston ring axial height and piston ring linear expansion in case that the cylinder bore is known.

17 Shrink fitting technique of cylinder liners, i. e. liners to be cooled down and then shrunk on cylinder bore freely,(www.Sentencedict.com) is introduced in detail with experimental examples.

18 The impacts of ethanol fuels on the tribological performance of CrN ring and cylinder bore were evaluated.

19 The lower one prevents the oil splashed onto the cylinder bore from entering the combustion chamber, and is called an oil ring.

20 The paper explains the micro-structure optimization of honed cross hatch on cylinder bore surface, determines its main characteristic parameters and proves them in test bed .